Equipment
Embedded Board Repair in Kenya
Embedded boards are often custom, undocumented or out of production. Sinsal diagnoses and repairs them by measurement, so the equipment they run can stay in service.
Equipment Covered
- Microcontroller control boards
- Single-board computers inside equipment
- Instrument and measurement-device boards
- Telemetry and IoT hardware boards
- Legacy OEM boards
- Prototype and low-volume boards
Common Faults
- Board powers up but does not run
- Resets caused by unstable supply
- Peripheral or bus failures
- Damaged crystals or regulators
- Corrupted flash
Diagnostic Process
- 01Identification of processor, memory and regulation stages
- 02Power-rail and clock checks first
- 03Reset and boot behaviour
- 04Logic analyser and oscilloscope checks on buses
- 05Hardware versus firmware determination
Repair Process
- 01Replacement of failed regulators, crystals and protection parts
- 02Repair of damaged tracks and connectors
- 03Hardware recovery of flash contents where applicable
Testing and Validation
- Rails, clocks and reset behaviour verified
- Peripheral checks that the board's role requires
- Extended run including warm-up
Frequently Asked Questions
Common Questions
Can you repair a board without a schematic?
Often. Measurement and circuit tracing identify the fault, and reverse engineering of the relevant section can be added.
Do you reprogram embedded boards?
Existing firmware can be recovered or restored at the hardware level where possible. Custom firmware development is not part of this service.
Have an Embedded Board That Will Not Start?
Describe the equipment and the fault. Sinsal will confirm whether it is a fit for diagnostics and repair before any work begins.
Already submitted equipment? Track your equipment