Equipment
CCTV and IP Camera Repair in Nairobi, Kenya
Cameras fail from surges, moisture and heat. Sinsal repairs the camera's electronics, covering power, PoE and network stages, to return units to service.
Equipment Covered
- IP cameras (dome, bullet, PTZ)
- Analogue HD cameras
- Camera power adapters and PoE injectors
- Camera network interface boards
- Outdoor housings' electronics
- Thermal and specialised cameras (electronics only)
Common Faults
- No image or no power
- Network link not established
- Surge damage to power and Ethernet circuitry
- Water ingress and corrosion in outdoor cameras
- Overheating from sun exposure
- PTZ motor-control faults
Diagnostic Process
- 01Record of the camera and its environment
- 02Inspection for moisture, corrosion and surge damage
- 03Bench power-up with rail analysis
- 04Checks on the power and network stages
- 05Repairability decision
Repair Process
- 01Replacement of failed regulators and protection parts
- 02Repair of corroded tracks and connectors where possible
- 03Re-inspection of the repair area
Testing and Validation
- Rail and boot verification
- Link check where a test setup is practical
- Extended run including warm-up
Frequently Asked Questions
Common Questions
Can a CCTV camera with no image be repaired?
Often, when the fault is in the power or interface stages. The assessment confirms the failed part.
Do you repair water-damaged cameras?
Sometimes. It depends on how far corrosion has spread, and assessment shows whether repair is economical.
Have Failed CCTV Cameras?
Describe the equipment and the fault. Sinsal will confirm whether it is a fit for diagnostics and repair before any work begins.
Already submitted equipment? Track your equipment